In the previous article we looked at administering RabbitMQ from the command line. In this next article we will set-up a basic queue and also send and receive a basic message via the management portal.
Before we go and dive into some code and look at our samples, let’s work through a very simple scenario where we create an exchange and a queue and bind them together via the management portal. We will then send a message to the exchange and pull it from the queue. It is a very simple example, but it serves as a good introduction before we tackle some real world scenarios.
First of all go to the management portal and click on the exchanges tab. Once you are on the exchanges page, open up the ‘Add a new exchange’ section and fill it in as shown in the following screenshot. You will then need to click on the “Add exchange” button to add the exchange.
This will add a new ‘direct’ exchange to the list of exchanges. Now click on the Queues tab at the top of the page to go to the queue list. Open up the ‘Add a new queue’ section and fill it in as per the following screenshot. Now click the “Add queue” button.